DESCRIPTION
The JaourTakTM is a synthetic rubber based hot melt pressure sensitive adhesive specifically developed for label applications where low temperature applied is required. The product can be applied at low temperature down to -20°C with high peel and tack, good wetting to substrates, and good die-cuttability.
SUGGESTED USES
Low temperature applied permanent labels, and/or other pressure sensitive applications that low temperature performance of tack and peel are required.
TYPICAL PROPERTIES
| Appearance | Yellow translucent solid |
| Color (Gardner) | ≤ G6 |
| Softening Point (R&B) | approx. 95°C |
| Viscosity (Brookfield) | |
| @120°C | approx. 101,000CPS |
| @140°C | approx. 36,500 CPS |
| @160°C | approx. 13,500 CPS |
| @180°C | approx. 7,100 CPS |
OPERATING GUIDES
The material can be applied by slot or roll coating applicators. Suggested operation temperature is 150 – 180°C for both, depending on machines, substrates, and plant conditions.
FDA STATUS
The product complies with the FDA Indirect Food Contact Regulation of 21 CFR 175.105, “Adhesives”.
PACKAGE
6.25kg or 1kg block wrapped with siliconized release paper, 25kg/box. Please consult the sales representative for special requirements.
STORAGE & SHELF LIFE
The material can be stored indoor for 12 months, from the date of manufacture, in its original packages under dry and clean conditions at ambient temperature below 350C and above 50C. Direct sunlight and moisture condensation must be prevented.
HAZARDS INDENTIFICATION
The product is not considered as hazardous within the meaning of the valid (EU) preparation directive.
Skin Contact :
Molten product adheres to the skin may cause burns
Eye Contact
Direct contact may cause eye irritation.
Inhalation :
Negligible hazard at ambient temperature. Vapors and/or aerosols which may be
formed at elevated temperature may be irritating to eyes and respiratory tract.
Ingestion :
No evidence of harmful effects from available information.
FIRST-AIDS MEASURES
Skin Contact :
Molten product. Immediately cool down the affected area by flushing with cold
water to dissipate heat. Seek medical attention.
Eye Contact :
If hot, immediately cool down the affected area by flushing with cold water to
dissipate heat. Get medical attention promptly.
Inhalation :
Move to fresh area. Get medical attention if irritation persists.
Ingestion :
No harmful effect expected.
FIRE FIGHTING MEASURES
Extinguishing media :
Water spray, foam, dry chemicals, and carbon dioxide.
Unsuitable Extinguishing
media :
Water in a jet may disperse fire.
Special protection
equipments for firefighters :
Use adequate personal protective equipments and self contained breathing
apparatus.
Unusual fire and explosion
hazards :
Not classified as flammable but will burn. Hazardous combustion products may
include carbon monoxide, carbon dioxide.
Product Tags:
|
|
Rubber Based PSA Industrial Hot Melt Glue For Freezen Label Images
|
